How To Fix Games With Toothpaste

Download Article

No matter what type of optical disk you have, scratches can make the data inaccessible. Surprisingly, "sanding" down the scratches with toothpaste is an effective home remedy, if the scratches are small.

1
Inspect the scratches. Toothpaste works best for shallow scratches and scuffs on the reflective side.^[1] It will probably not work on a deep scratch. Scratches on the non-reflective label side should never be rubbed, and may have caused irreparable damage.
- If you have deep scratches, consider sending the disk to a disk repair service. You could also try more abrasive treatments, such as a non-petroleum-based metal polish.^[2]
2
Dampen a soft, lint-free cloth. Lightly dampen a cotton or microfiber cloth. You'll use this to clean grime off the disk. If you skip this section, the toothpaste could rub dirt particles into the CD, making the scratch worse.
- Avoid any rough or dusty materials.
- If the disk is visibly greasy or dirty, wipe it under running water.
Advertisement
3
Wipe the reflective side of the disk. Gently brush the wet cloth against the disk. Wipe each stroke outwards from the center, like a spoke on a bicycle wheel. Rubbing in circles increases the risk of damage.^[3]
- Hold the disk by the rim to avoid adding additional dirt and oil from your fingers.
4
Dry the disk carefully. A dry cloth is more likely to damage the disk. One of these methods of drying are recommended instead:
- Place face down on a couple layers of paper towel and wait until dry.
- Loosely wad a paper towel and brush from the center outward. Do not push onto the disk; the only pressure should come from the bending of the paper towel.^[4]
- Let air dry.
Advertisement

1
Choose the toothpaste. You must use actual paste, not a gel toothpaste. The paste contains abrasive material that scrapes plaque off your teeth. This will sand down the scratched surface as well, hiding the scratch causing the laser to misread.^[5]
- Baking soda toothpaste works well due to the extra grit.
- If you're lucky, your toothpaste will list an abrasion rating, called RDA. No one's tested how RDA affects disk cleaning, but a higher rating (120+) should work better.
2

Apply a small amount of toothpaste to the polishing cloth. A small dab should be enough. As before, use a clean, lint-free cloth such as cotton or microfiber.
3
Gently rub the toothpaste over the disk. Always move radially, from the center of the disk straight out to the rim. Do not rub in circular motions. Continue rubbing gently until the scratch is gone or nearly gone. This can take a few minutes.
- Do not polish harder in an attempt to speed up the process. This can cause further damage to the disk.
4

Wash the disc off with cold water. Ensure that you remove all of the toothpaste. You may need to use a clean polishing cloth to remove residue, using the same wiping pattern.
5

Dry the disk. You may wipe it with a dry cloth, but blotting with a paper towel is safer. You should notice that scratches are fainter or even completely gone. You may have made some additional tiny scratches, but provided that you did not press hard, these shouldn't interfere with the disk.^[6]
6
Test the game. Place the disk into the appropriate drive and see if it works. If so, then you are done. If not, repeat the toothpaste treatment for a second round.
- If there is no noticeable improvement at all, try again with a grittier toothpaste, or with petroleum-free metal polish.
- If two rounds of polishing do not work, try sending it to a disk repair service. These can buff out the scratches with a special machine.
Advertisement

Add New Question

Question

Can I use regular toothpaste?

Any toothpaste designed for adults should work.
Question

Will this work with PlayStation 1 games? If so, how?

This works with pretty much any disc or cd. Use the same method and it should be fine.
Question

What about PS4 games? Can I do the same thing?

No. PS4 discs are Blu-ray, different materials than regular discs. Take it to a Gamestop and they can fix it.
Question

Can I use toothpaste to fix deep scratches?

No, a deep scratch cannot be fixed by using toothpaste. You should to send it to a disc shop or a store that specializes in fixing discs.
Question

Will these ideas work on badly scratched disks?

Not if the scratches are too deep. This only works on relatively light scratches.
Question

There is toothpaste stuck in the inner rim of the disk. How do I get it out?

Wait until it dries and use a brand new toothbrush and very delicately use the bristles to clean it out.
Question

Will this method work on a PS3 disc?

No. PS3 Discs are Blu-ray, so they are made of different material than other discs.

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Be consistent. It's better to press with the same force and move at the same speed because it ensures a smooth resurfacing.

Thanks for submitting a tip for review!

Don't press too hard or polish the disk too many times, as you'll risk damaging it even further.
This method is designed to combat light damage by polishing away the surrounding areas. If your disk is severely damaged, you won't be able to polish it deeply enough to "remove" the scratches without damaging the disk in the process. If this is the case, explore additional disk-repair options.